Can you use Braceline as Aqualine?

Can you use Braceline as Aqualine?

GIB Aqualine® can be used in place of GIB Braceline® in GIB® bracing elements 900mm or longer, provided the perimeter of the element is fixed with GIB Braceline® Nails or GIB Braceline® screws at 100mm centres, using the GIB Braceline® corner fixing pattern.

Can Braceline replace Fyreline?

13mm GIB Braceline® / GIB Noiseline® can be replaced with: 13mm GIB Aqualine® (see Notes 1 & 3 below) 13mm or thicker GIB Fyreline® (see Notes 1, 2 & 3) 13mm GIB Toughline® (see Note 3) 13mm GIB Toughline® Aqua (see Note 3) Note 1: The bracing element must be 900mm or greater in length.

Is GIB the same as plasterboard?

GIB Barrierline® plasterboard is a key component in the GIB® Intertenancy Barrier system. Refer to GIB® Intertenancy Barrier or GIB® Noise Control Systems literature for installation requirements.

How far apart should Gib screws be?

If end joints are required when fixing horizontally, these should be staggered a minimum of one stud apart, 600 mm. Stud spacing should be at a maximum of 600 mm. For older, existing homes stud spacing may require that GIB® plasterboard sheets be trimmed when fixing vertically.

Do you need to plaster GIB before tiling?

GIB Aqualine® must not be directly applied to solid plaster (gypsum or cement), wood based sheet linings or similar materials, masonry or concrete. GIB Aqualine® may only be applied to these materials where timber strapping or steel furring channels are installed.

What can I use instead of GIB?

Plywood and other timber Structural plywood is an option to consider, especially if you are still at the design stage. But it is considerably more expensive than Gib, and a totally different look – it is usually stained, so the grain is exposed.

Is Braceline fire rated?

Its higher density core can reduce noise transmission between rooms and also between floors in two storey homes. Other benefits of this product are its 30 and 60mm fire ratings when used in a fire systems. Its increased strength and stiffness gives a more solid walls and ceilings.

What is Fyreline?

Product Description. GIB Fyreline® is a high performance fire resistant board. GIB Fyreline® systems provide from 1/2 hour to 3 hours fire protection on standard 600mm timber or steel frames. GIB Fyreline® is the ideal lining for dividing walls, lift shafts, stairwells and/or anywhere that fire could be a threat.

Can you use 10mm plasterboard on ceilings?

The plasterboard sizes for ceilings are 9.5mm or 10mm.

Can you use 10mm GIB on ceilings?

Used in ceilings it can withstand distributed loads up to 3.0kg/m2 easily supporting loads such as R5. 0 insulation. GIB® Standard plasterboard is an economical lining material available in 10mm and 13mm thicknesses.

How far off the floor should drywall be?

a ½ inch to ⅝ inch
It might sound counter intuitive at first to leave space between your floor and your wall, but you should always leave a ½ inch to ⅝ inch gap between drywall and the floor.

Should you leave gaps between drywall?

Always leave a 1/2-inch gap at the floor. This allows for floor and wall expansion without cracking the drywall.

Can I tile straight on to plasterboard?

Yes. You can tile directly onto plasterboard, just make sure to use an acrylic-based primer. Once the primer is dry, you can then apply a powdered adhesive.

Can you tile directly onto Gib?

10mm and 13mm GIB Aqualine® are suitable for tile weights up to 20kg/m² on timber framing, and 13mm GIB Aqualine® on steel framing and for tile weights between 20 and 32kg/m². Liquid applied water proof membranes and tile adhesives readily adhere to the GIB Aqualine® face liner and GIB® jointing compounds.

How do you smooth walls without plastering?

How to Smooth Walls Without Plastering in 2022 (5 Methods to Follow) – DIY UK Guide

  1. Fill Holes or Cracks. Before you do anything, fill any holes and cracks in your wall.
  2. Sanding. If your old plaster is a bit lumpy and bumpy, sand it to smooth out any bumps.
  3. Clean the Wall of Scuffs & Marks.
  4. Hang Wallpaper.
  5. Paint Your Walls.

What is Braceline GIB used for?

Dual board GIB Braceline® GIB Noiseline® is an effective wall bracing sheet for light timber framed buildings. It is also a high performance plasterboard designed specifically for reducing the level of sound transmission between rooms.

What is a 30 minute fire rated wall?

Thermoguard Timbercoat 30 Minute System This means if a fire breaks out, a surface that has been treated correctly such as an interior wall, will be protected from the effects of a fire by a protective layer that is guaranteed to last for 30 minutes or 60 minutes, dependent upon which level is chosen.

What is Gib Fyreline made of?

4.2 GIB Fyreline® is a paper-bound gypsum-plaster core sheet lining material. Glass fibre and other additives are added to the core during manufacture. The sheets have a taper on the two long sheet edges.

Can I use 9.5 mm plasterboard on walls?

The most common plasterboard thickness is 9.5mm and 12.5mm. For ceilings is used 9.5mm thick plasterboard and for walls – 12.5mm.

Why choose braceline orthodontics?

All staff at Braceline Orthodontics have been trained to an extremely high level at International Standards. Braceline Orthodontics is committed to providing the best service possible to our clients in an efficient and friendly manner.

Why choose nails plus?

At Nails Plus, our customers—whether at-home nail experts or salon owners—rely on us for their nail art needs. As such, wholesale nail tips and the…

What kind of laser does braceline use?

Braceline uses a Spectralase Diode Laser, one of the most sophisticated soft-tissue lasers for use in orthodontics. We are very proud of our extremely highly qualified and friendly team members at Braceline.

Which brand of braces is the best?

Braceline is the best .They are advanced, New technologies are introduced all the time and they have a wide range of braces to choose from.