Can you replace Sportdog remote?
Can you replace Sportdog remote?
Replacement transmitter for the FieldTrainer® 425 and 425S. The SD-425 system is fully customizable, allowing you the flexibility to set 2 or more transmitters to control the same collar receiver. Consult your Owner’s Manual for set up instructions. Connecting to the server.
How do I reset my sport dog transmitter?
Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5 times. You may need to hold both units 2-3 feet from each other before this occurs. Once the Receiver Indicator Light has flashed 5 times, the Collar Receiver has been reset and will begin flashing as normal.
What does V t mean on a shock collar?
If the dial is set to V/T, in this mode, and any button is pressed, then no signal will be sent to the Collar Receiver.
Why is my dog’s shock collar not working?
Make sure your battery is charged in both the collar and the transmitter. Low battery charge can make for inconsistent functioning. Make sure both pieces are turned on and that the unit is properly synced so that the collar is receiving a signal from the transmitter.
How do you pair a dog collar with a remote control?
Match the Remote Control to the Receiver: Connect the Receiver to a power source via the USB cable, matching mode can only be activated during charging. Press and hold Channel Switch / Match Button for 5 secs. The Receiver will vibrate and beep which indicates the matching is complete.
Why did my shock collar stop working?
Is a vibration collar cruel?
Will a vibration collar hurt my dog? Nope! Vibration collars will simply send a buzz to your dog’s neck. They will not shock or cause Fido any pain.
What does red light mean on Sportdog collar?
TO TURN THE COLLAR RECEIVER OFF The Receiver Indicator Light comes on solid (red) and the Collar Receiver beeps continuously for 2 seconds. To extend the life between charging cycles, turn the Collar Receiver off when it is not in use.
Why is my Sportdog collar not working?
You may need to hold both units 2-3 feet from each other before this occurs. Once the Receiver Indicator Light has flashed 5 times, the Collar Receiver has been reset and will begin flashing as normal. If the Receiver Indicator Light does not flash 5 times, start over and repeat from step 1.
What happens if you shock your dog too much?
The anxiety and confusion caused by repeated shocks can lead to changes in a dog’s heart and respiration rate or gastrointestinal disorders. Electronic collars can also malfunction, either administering no shocks at all or nonstop shocks.
Do vets approve of shock collars?
The British Veterinary Association and the British Small Animal Veterinary Association both recommend “against the use of electronic shock collars and other aversive methods for the training and containment of animals” and state that shocks “and other aversive stimuli received during training may not only be acutely …